author: american welding society

Requirements are presented for the design and fabrication of constructional steel weldments that are used in industrial and mill cranes, lifting devices, and other material handling equipment.

This specification makes use of both U.S. Customary Units and the International System of Units (SI). Since these are not equivalent, each system must be used independently of the other.

Clause 1includes general provisions, Clause 2 design , Clause 3 prequalification, Clause 4 qualification, Clause 5 fabrication, Clause 6 inspection, and Clause 7 stud welding."--T.p.

Requirements and limitations governing procedure and performance qualification are presented, and workmanship and inspection standards are supplied. The informative annexes provide useful information on materials and processes.

Additional requirements cover repair welding of existing hardware. A commentary for the specification is included.

This standard is a glossary of the technical terms used in the welding industry. Its purpose is to aid in the communication of welding information.

This specification makes use of both U.S. Customary Units and the International System of Units (SI). Since these are not equivalent, each system must be used independently of the other.

This specification makes use of the International System of Units (SI) and U.S. Customary Units. Since these are not equivalent, each must be used independently of the other.

This volume presents comprehensive information on welding and related processes to include detailed information on arc welding power sources; shielded metal arc, gas tungsten arc, gas metal arc, flux cored arc, submerged arc, and plasma arc ...

... 6. Inspection . This section contains criteria for the qualifications and responsibilities of inspectors , accep ... AWS D1.3 , Structural Welding Code - Sheet Steel , should apply . When used in conjunc- tion with AWS D1.3 , conformance ...

... welding for laminations and lamel- lar tearing . Any base metal discontinuities found within 1/4 of the steel surface adjacent to the fusion line shall be accepted or rejected on the basis of criteria of AWS D1.1 / D1.1M Table 6.2 . 7.6 ...

This standard defines the qualification requirements to qualify welding inspectors.

This standard establishes a method for specifying certain welding, brazing, and nondestructive examination information by means of symbols.

... ANSI Z49.1 : 1999 , Miami : American Welding Society , pp . 16-17 . 61. American National Standards Institute ( ANSI ) Accredited Stan- dards Committee Z49 , 1999 , Safety in Welding , Cutting , and Allied Processes , ANSI Z49.1 : 1999 ...